That’s just really poorly applied paint. I could try that though.
The plastic slides a little but more so because it’s probably a tiny bit small that it has wiggle room
That’s just really poorly applied paint. I could try that though.
The plastic slides a little but more so because it’s probably a tiny bit small that it has wiggle room
No we’re pretty certain that wire comes out in the basement. There’s almost an identical one directly underneath the house.
I did test it with the switch to be safe and it was a no go. It could be dead all around though. I don’t think that’s a outdoor cable
I’m redoing a lot of the lighting so that’s not a project I’m afraid to tackle. Last owner loved florescent lights so we’re removing them from the bedrooms and bathrooms currently.
Inside looks pretty much the same. My biggest fear is breaking it apart and not being able to reassemble it because it leaves a pretty big hole to get inside the house. If I can get in without breaking it I can fix whatever is in there.
Not sure when the door was installed but the house is 1880’s so it has quite a span to be from. I doubt it’s original but it can be quite old.
I don’t think so. We found a mysterious wire in the basement that goes outside to nowhere directly below it. Either way that doesn’t work and I’m just trying to find the best/least damaging way to remove it.
But it did cross my mind and I tested it with the switch on and off and it worked with neither. That being said I don’t think it’s an outdoor rated plug so it could just be bad either way.
It’s on the list. We just got carpet laid downstairs and still need 2 more rooms done, we got a new furnace/ac, and are now installing interior stairs. It’s a big project overall cause we’re converting a duplex to a single family home. But eventually new locks will be put on.