It is a hollow door, but the amount of planing needed at the bottom is minor, I am more worried about the 1/4” gap at the top.
It is a hollow door, but the amount of planing needed at the bottom is minor, I am more worried about the 1/4” gap at the top.
I was thinking of trying an o-ring on the door way and starting over. Maybe a Swords to Plowshares, since it is a wall I likely do not have to worry about the life gain.
I am worried about replacing the frame because I have seen the quality of work the previous tenants did and I have a feeling under that frame is worse than what I am seeing.
The door is upside down because of the hinges. If I turn it left-side up the hinges face into the frame. When I redo the notches for the hinges I planned to flip the door, but since half are still on the door itself it will not go into the frame as is.
More than two, those are entire stacks of mana I am using to hold the door in place. I also have a table with a short leg that is leveled with a stack of mountains.
A sheet of plywood instead of a door? Being as this is the middle of my shop, I will pass on that.