themeatbridge

I remember learning that 3.5" disks were still called “floppy” disks, despite being rigid plastic. My teacher took apart a disk and showed us how the inside was a film, but all that did was encourage us to take apart the disks and make desk toys out of the springs.

Man, I remember when Zip Disks were a big deal and a GB was a lot of storage.

I love that this exists, and thank you for introducing me to the site as well.

Oh, I see. My apologies, I misunderstood what we were looking at. I thought the framing we see was the entire wall, but it’s just non-structural framing on the interior behind the plasterboard to allow space for wiring.

I am not familiar with this style of construction, so I won’t guess at best practices for hanging cabinets on it. But I would imagine that as long as the wall we see is sufficiently secured to the structural wall behind it, you should be able to hang cabinets. To be safe, you could anchor into the wall, but I don’t know enough to say how to do that without interfering with insulation or vapor barriers.

My advice? Knock that “wall” down and pay a proper carpenter to build a proper one. Your studs are too small, they don’t go all the way down, you have no room for insulation, and if you try to hang cabinets on that thing, you’re going to kill someone when the whole sumbitch collapses.

My bad, I didn’t know what I was looking at. See OP’s diagram to learn more about this, and ignore my ignorance.

Jesus, good decision. Call an electrician because you’re not going to know what else whoever put that in did.

Looks to me like something is scorching the wall. Could have been something inside the cabinet, like putting away a cast iron pan while it’s still hot, but my guess is you have a screw in the wall there that is screwed into a shorted electrical cable.

I could definitely be wrong, but I’d cut a hole and see what’s back there anyway.

What do you use the Pi for now?

I had a bunch of Pi 3Bs sitting around, so I made piholes for a few friends and family, I made a dedicated MAME emulator that I never have time to play, and I gave one to each of my kids to learn about computers and linux. I also use one for work as a linux test environment for our software, but the 3 hardware doesn’t really keep up.

I would be very interested to read this in an article format, but I have zero interest in watching a video about it.

I haven’t done it myself, so I hesitate to recommend a specific project. But Carpi and OpenAuto are good places to start.

Why risk it? Build your own with a raspberry pi and a touchscreen.

Wait, I feel like I missed something important. Hannah Montana Linux?

Edit: It’s real. It’s really real.

What’s on the other side of the wall?

Regardless, I wouldn’t use the sealant you have. That’s a huge hole. Expandable foam could do it, but it might need to be fire rated if that’s a shared or exterior wall (check local code requirements), and that might be a bigger hole than foam recommends. Also, if there’s nothing behind the wall, the foam might just fall back into the void. Expandable foam also looks like shit, so if the spot is visible, do something that looks more finished.

The right way to do this would be to make the opening in the cabinet large enough to properly repair the wall. Cut a rectangular patch that fits around the pipes and secure it to studs, then spackle. If you make the gap smaller, then you could use the flexible sealant, but I still wouldn’t use clear.