Hello everyone,
I hope you’re all doing well. I’m reaching out for some guidance on a network project I’ve been working on.
Currently, my setup includes:
- OPNsense Firewall: This is running smoothly and is the primary gateway for my network.
- Proxmox Server: I’m in the process of integrating this. It has a single Ethernet port for network connectivity.
My primary goal is to deploy a Pi-hole instance on the Proxmox server. I’m still weighing whether to go with a Docker container or a standalone VM for this.
Here’s the crux: My existing network devices operate in the 192.168.0.1xx IP range. I’d like the Pi-hole to be on a different subnet, specifically 192.168.33.xxx. This move is mainly for organization and segmentation purposes.
Considering the single Ethernet port on the Proxmox server and my intended setup, is this feasible? Moreover, are there specific challenges or configurations I should be aware of?
Any insights, advice, or shared experiences would be invaluable.
Thank you for your collective wisdom and time!
Uptate
so for all you people looking I managed to get it to work with this guide
Firewall Rules:
Allow Main LAN to Access the New Subnet:
Log into the OPNsense web interface. Go to Firewall > Rules > [LAN]. Click on the + button to add a new rule. Set the following:
Action: Pass
Interface: LAN
Protocol: Any (or you can specify TCP/UDP if needed)
Source: LAN net
Destination: Single host or alias and input 192.168.33.0/24.
Add a description (e.g., “Allow LAN to Access 192.168.33 Subnet”). Click Save.
Allow New Subnet to Reply (or initiate to the Main LAN):
- Go to Firewall > Rules > [Your VLAN interface, e.g., VLAN33].
- Click on the + button to add a new rule.
Set the following:
Action: Pass
Interface: [Your VLAN interface]
Protocol: Any (or you can specify TCP/UDP if needed)
Source: 192.168.33.0/24
Destination: LAN net
- Add a description (e.g., “Allow 192.168.33 Subnet to Access LAN”).
- Click Save.
Apply Changes:
After creating the rules, click on Apply Changes to ensure the rules take effect.
You must log in or register to comment.
Look into vlan.
Basically allows you to have different subnets rubbing on a physical network card.
It is possible what you want to do and not that complicated.
Subnetting and VLANs can get hard to conceptualize when they are virtualized on a single machine.
I’d suggest going to draw.io and making a logical network diagram so that you can have a reference when setting up your network.
If you want EVERYTHING going through piHole which is on a different subnet, easiest way I’ve done it was make going through the pihole necessary to make it to the default gateway.
But if you have a different situation for pihole you can set up DNS relays.
yeah I should draw it out first. Right now traffic is routed trough a pihole on a raspberry
I think I will keep this route
